4/26/2021 0 Comments Dhcp Helper In Fortigate
It shouldnt matter that VLAN 66 on the FGT is pointing to the same DHCP server as VLAN 1, correct Windows is supposed to recognize the VLAN and assign accordingly (to 66) Thank you for your reply.The 66 subnet is a new addition, where previously all addresses were being assigned from the 64.On the Fortigate, all traffic (FortiOS 5.6.1) on the internal switch has been running on the default VLAN (ID 1).
I created the 66 subnet and added it to AD Sites and Services. I also adjusted the lease time on the 64 DHCP pool to 24 hours just to force my clients to check back at least once a day to see if theyre getting address from the new pool. On the FGT100D, I unassigned some unused ports on the internal interface to a new hardware switch with address xx.xx.66.124, and configured the DHCP relay to point to my DHCP server (sitting on the 64 subnet). Ive got a Dell x1018p connected to the ports assigned to the 66 switch, but when i connect a client to the Dell, theyre still getting addresses from the 64 pool. Im not sure Im fully understanding your second question, but previously, all ports on the internal switch were assigned to the default VLAN. Should I create a VLAN 66 for the 66 switch, and give it an address of 0.0.0.0 Will that let all ports on the 66 switch respond to requests on IP address xx.xx.66.1 (the IP of the whole interface) I hope that made sense, I actually confused myself writing it. Do you get the same results (DHCP IP from the 64 subnet) if you plug a. Just want to clarify since you mentioned pool a few times and no mention of a new scope. ![]() However, if both of the 64 and 66 interfaces on the fortinet are connected to the same switch, you would need to use VLANs on the switch to segregate the two subnets. Sorry, Ive been using those terms interchangeably, even though theyre different. Ive gone through so many permutations, Im almost certain Ive tested by plugging directly into the 66 interface on the FGT and received a 64 address. In short order, though, Ill have a scenario like you describe, with one switch configured with two VLANs, connected to the FGT. Thank you. The new VLAN ID is 66, and the ports on the Dell have been assigned to that VLAN.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |